introducing the 10 Minute Deer Skinner

"Modern Technologies with Pioneer Spirit"

Order By Phone, Toll Free 1-800-354-0637

10 Minute Deer Skinner

10 Minute Deer Skinner

Absolutely the fastest and easiest way to skin a deer

Keeps meat clean from hair and other contaminants

Professional method of skinning, minimal cutting and reduces nicks in hide

Uses the power of your vehicle to quickly and efficiently remove deer skin

Deer Skinner Kit

Only $39.95 +S&H

Buy Online

Deer Skinner Kit Includes:

Instructional Video Tape

Camo carrying bag

Plain cable with looped ends

Long cable containing the skinner plate and two stage ball.





How to use the 10 Minute Deer Skinner

by Ben Fritz

Important: View instructional video tape and read these instructions completely before using the 10 Minute Deer Skinner (Patent Pending).

The 10 Minute Deer Skinner is the most time efficient method that we've found (using the least amount of physical effort) to take a deer from the buck pole to the deep freeze. Your deer must be properly field dressed and placed on a clean sheet of plastic (2 mil. drop cloth suggested) before the 10 Minute Deer Skinner is utilized.

Extend the skin cut on the deer from the field dressed cut to the base of head. (Two to four inches from the head.) From the end of this cut, make a complete circle around the neck, connecting with the original cut. Important: Cut skin only, not the meat.

Attach loop of plain cable to an immovable object (tree, stump, ball hitch of parked vehicle, etc.). Slip the loop on the other end of plain cable around the deer head, behind the ears, and hand tighten (see Figure 2). From cut on back of neck, pull hide back toward the tail six (6) to ten (10) inches.

Cut skin on each front leg from knee joint to brisket cut. Make a cut circling the knee joint. Note: DO NOT PULL SKIN. Again, cut skin only, not meat. Brush hair off drop cloth, and clean area around the deer, so the skinned carcass will drop on a clean surface.

This step will utilize the two stage ball and skinner plate for hide removal. Take the long cable that contains the skinner plate and two stage ball (see Figure 1); and place the skinner plate (flat surface down) on the raw side of the hide. Push the small end of the two stage ball from the hair side of the hide, through the hole in the skinner plate (see Figure 3). Hand tighten cable around the narrow section of the two stage ball by pulling only on the coated end of the cable.

Note: Only the small side of the two stage ball should push through the skinner plate. Be certain there is enough loose skin to cover both the small and large portions of the two stage ball. Any exposed surface of the two stage ball will cause the skin to slip out of the cable.

Place other end of cable on ball hitch of a moveable vehicle. Be sure that all cables are now in place, and tightly secured between immovable object, deer, and vehicle.

Advance vehicle (slowly) to remove slack. Hunter should stand to the side of deer for safety reasons and to signal the driver. Vehicle should be advanced (see Figure 4) until skin is removed to the hind leg joints. Cut skin around each back leg between knee and ankle joint. Resume truck advancement (if necessary) until skin is completely removed. Your deer should be completely skinned and dropped back on a clean, plastic surface (see Figure 5).

Note: If the animal has been down for an extended period of time, the front legs of the deer may need to be moved toward rear to permit clean skin removal around the legs. Also, if the hide is to be kept, skin tail by hand (as shown in video). Finally, if the hide is to be tanned, split each back leg open from hind quarter to end of leg.

Exclusion Of Warranties and Warning

TO THE MAXIMUM EXTENT PERMITTED BY LAW THERE ARE NO IMPLIED WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE OF THESE INSTRUCTIONS AND THERE IS NO IMPLIED WARRANTY OF MERCHANTABILITY EXCEPT THAT THE MATERIAL SOLD SHALL BE OF SELLER'S STANDARD QUALITY and buyer and or user assumes all risk and liability for all loss, damage or injury to person(s) or property resulting from the use of the 10 Minute Deer Skinner ™1995. Any use inconsistent with these instructions voids all warranty. The 10 Minute Deer Skinner ™1995 should be used only by an adult, and any use by minors should be done only with adult supervision. This product, and the components of this product, are specifically designed for use only as described in the above instructions. Do not exceed load limit of 300 pounds.10 Minute Deer Skinner, Patent Pending




Ten Minute Deer Skinner


Skin Deer'sNeck


Hook to Deer Hide


Slowly Pull Deer Hide


10 minute deer skinning











Order By Phone, Toll Free 1-800-354-0637

Return to Innovative Products for the Sportsman